I was accessing the web via 192.168.1.xxx because this is another vlan dedicated for administration.
Siemens Hipath 4000 Manual Push TheThat happen sometimes and then I reset the unix using init 0 or manual push the buton method.I had this problem year ago and the problem was with the sim card, I pulled out the ADP and reinsterted the SIM and the card, my friend from Siemenes typed a few mmls and it was working.But now when I pulled out the ADP and cleaned all the contacts the situation is the same.
Siemens Hipath 4000 Password For ThisMaybe there is a password for this logon, so I have noticed the healthy other PBX is also asking me for other credentials when I want to connect to it usin Comwin expert access. It sounds as if the automatic re-installation occurred, since you say the old password no longer works. Sorry, but I cannot provide the default password on this forum. If you made a mistake while typing, and you actually meant to say 192.0.2.5, then that is a different story. That is the IP address assigned to Unixware via the Atlantic LAN, and no automatic re-install has occurred. Note: Unixware should not be stopped by pushing the reset button on the ADP. Unixware needs an orderly shutdown, or it can become corrupted, which will warrant a re-installation from RMX Scratchpad. You should always shutdown via command (init 6 ot init 0) or use Assistant Base Admin Unix Base Admin Shut Down. On newer 4K systems, Unixware can be shutdown via AMO DSSM, but not sure about V3. Good Luck. My first step would be to evaluate the PC you are using to try to use web access. I am using the latest version of the switch, and I will bet it took me well over an hour to load all the crap that is required of web management. You had to have just the right version of Java, certificates, add on components and all kinds of other junk. Siemens Hipath 4000 Update You MightIf you downloaded a Java update you might have messed yourself up, or one of the other component requirements could have been upgraded on the fly - things like that. The address you listed your your customer LAN port is pretty strange. Is the whole network in your organization really using 192.1.2.X for IP addresses Ours are all 10.1.x, 10.2.x, etc. Normally if you are using a 192 network it would be 192.168.x.xxx type of addresses. We have ours hooked up to a 5-port switch so I dont have to think about it. How do you know the process for the Administration service is not running Are you logging in through expert mode to somehow see it isnt running. This address is typically changed to an IP address within the customers net scheme during the system installation. So if you can use this IP address, then either it was never changed during the system installation, OR Unixware has been recently re-installed. My address scheme is 10.1.xxx.xxx My tech did not change the address for the adp customer and atlantic ports, I can access via web connecting to atlantic port using 192.0.2.5 and via customer port on 192.1.2.5 but cannot access via my old password.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |